Pint365 Assembly

Pint365 Assembly

Step 1

Decide where you want to use your Pint365.  The unit weight is approximately 9kg so please ensure that you choose somewhere robust enough for you to mount and somewhere that will be able to cope with the counter balance action of the handle being pulled. Attach your Pint365 to the worktop/counter by tightening both clamps until completely secure.

 

Step 2

Take the insulated pipe and attached the grey John Guest fitting to one end and the black John Guest fitting to the other

 

Step 3

Take the grey fitting and push it firmly onto the Inlet feed at the bottom the CaskMaster.

 

Step 4

Identify which of the following fittings your beer has:

 

Polypin has a white tap and a Bag in Box has black and red tap then follow the relevant step below:

 

  1. Bag in Box (Black and Red Tap) Push the black John Guest fitting onto the Vitop connector.

Remove the red tab (seal) and then slide the Vitop connector over the top of the red tap and twist the nut on the top of the Vitop connector downward.  This opens the tap and allows the beer to be drawn out.

 

B.    Polypin (White Tap) Push the black John Guest fitting on to the white tap ensuring its completely on.  Fully rotate the white tap lever to the open position. This will allow the beer to be drawn out.

 

Step 5

You are now in a position to pull beer. Please note that the first couple of strokes will be “charging” the pump ready to pour and no beer will actually dispense.  Once the Pint365 is charged use a controlled tempo to pull your perfect pint


19th June 2019

Back to news